![]() I also recommend resisting the urge to smack the threaded stud with a hammer - first off, its unlikely to work without significant effort (that's what the press is for) and second, you risk "mushrooming" the stud so badly that it wont fit through the hole in the ball joint "cup". If you expect the ball joint might fall out after you remove the retaining nut, Ive got some Ocean-front property in Nebraska I'd love to sell you. It will be necessary to remove the Zerk / Grease fitting (7/16ths I think) and then the retaining nut. So here is what you?ll have once the brake / hub assembly and spindle has been removed.Ĭlose up of our patient, the upper ball joint This got me around 20 different tubes and adapters to play around with and find the combo that would work. I bought the ADT tools 8699 Master Ball Joint Service Set. Since I didn?t know what combination of adapters and tubes I?d need, I decided to buy a fairly comprehensive kit. Good news for you is that I provide those details below. Even the manufacturers that provided an online PDF of their application chart rarely went older than ?72. The key thing though, is that you need specific install and removal ?tubes? and nobody I talked to could tell me which I needed. Its also very likely that your local auto parts store can rent you this tool. A quick search on Amazon ? Ball Joint Press? and you?ll see options ranging from small kits to ?Master Kits? and prices ranging from around $40 to $500. The first thing you?ll need is a ball joint press kit. This process may work on other years with a pressed-in ball joint, I can?t see why not, but this was done on a 1963. I didn?t find other posts with any particular details on this, so perhaps this will be of use to others. So to that end, I?ve written up some details and provided pictures of my successful effort to replace the upper ball joints with the control arm in place. ![]() ?Death by springing? aside, its not always necessary, convenient, or particularly desirable to disassemble the front end to replace a ball joint, especially if you have a single afternoon and less than four hours before a troop of kids arrives to interrupt your garage-borne serenity. ![]() While doing all that might be worthwhile, it essentially doubles the work ? possibly more, and adds an additional element of ?danger? - the spring removal process isn?t without its challenges from a safety perspective. The most common process seems to be to remove the upper control arm, which requires removal of the spring, etc. A key difference in ?63 versus 61 and 62 bullet birds is that the upper ball joint is pressed in, not riveted like the lower. Last weekend I replaced my upper and lower ball joints, inner and outer tie rod ends, center link and idler arm.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |